BLOQUE STOP

PRESENTATION

HOW DOES IT WORK ?

Safety system which can adapt itself on sliding windows opening of the internal panel towards the left or towards the right.

schéma bloque stop

BLOQUE STOP installs itself at the foot of the internal panel (I), on horseback on the inside of the runner rails (G).

Once set up, BLOQUE STOP will block both sliding panels simultaneously.

The stalk (A) (the blocker) and the appendix on it's extremity, function by screwing up to the panel (C), into the pre-drilled hole on the outside panel (H), designed to accommodate the screw. This blocks the first panel on its rail, and, by inverse push, puts the side (E) of BLOQUE STOP in contact with the rail (G), therefore blocking the internal (I) on its rail.

A note of installation is supplied with the BLOQUESTOP.

Simple, sure, effective (easy installation within 10 minutes)

outillage nécessaire
    Equipment necessary for the installation :
  • A drill
  • A Phillips screwdriver
  • A black felt-tip pen
  • One 2mm diameter drill
  • One 6mm diameter drill
  • One 8mm diameter drill
  • Two steel screws with countersunk heads, diameter 4mm, length 15mm (supplied)
  • Two white screw head covers (supplied)